Use the gowns correctly

• Always follow the instruction of wearing proper gowns

• Make sure the gowns are suitable and correct for the environment and potential risks

• Gowns are worn or used according to right steps and take necessary preparations

• Take necessary cleaning or sanitizing before wearing

• Make sure any part of your body which needs to be protected, get well protected

• Different gowns can be used together for further and total protection

• In all cases involving contaminating materials attention must be paid to correct taking gowns off

• After using, take necessary cleaning once again

Guide to protective descriptions

EVA+PP40g(Level 1)

These are the standard fabric for basic protective gowns; formed by bonding fibers together to from a single layer of breathable, woven-like material. Its main advantages are economy and comfort, but it also provides light fluid protection.

ANSI/AAMI PB70:2012 

Water repellency-impact penetration test(AATCC42) ≤4.5g

PP+PE 45g(Level 2)

These are the fabric spundonded Polypropylene with PE fabric to a two-layers isolation gown, Waterproof,Strong and lightweight and cost effective; Can be used for low to middle-end fluid contact. 

ANSI/AAMI PB70:2012 

Water repellency-impact penetration test(AATCC42) ≤1.0g; Hydrostatic head test(AATCC 127)≥20cm.H2O

Multi-Ply Material (SMS, Level 2 is 25g&3 is 35g )

A multi-ply material consisting of layers of meltblown polypropylene between layers of spunbond polypropylene. Strong, fluid-resistant and breathable, this multi-layer material provides and optimal mix of protection and comfort. Appropriate forextended wear situations involving low to moderate fluid contact.

ANSI/AAMI PB70:2012 

Water repellency-impact penetration test(AATCC42) ≤1.0g; Hydrostatic head test(AATCC 127)≥50cm.H2O

Multi-Ply Material (SMMS 35g, Level 3)

A material even better than SMS Strong, fluid-resistant and breathable, has sterile and non sterile version. 

ANSI/AAMI PB70:2012 

Water repellency-impact penetration test(AATCC42) ≤1.0g; Hydrostatic head test(AATCC 127)≥50cm.H2O

CPE 40g( Level 3)

This material has certain heat resistance, oil resistance, ozone resistance, chemical resistance, aging resistance, heat resistance and other properties.

ANSI/AAMI PB70:2012 

Water repellency-impact penetration test(AATCC42) ≤1.0g; Hydrostatic head test(AATCC 127)≥50cm.H2O

Categories/Sectors

• Medical Purpose/Operation

• Healthcare/Ward

• Food Processing / Kitchen

• Cleaning / Housework

• Laboratory/General Purpose

• Industrial Purpose / PPE

• IT Industry/Clean Room